Installation method of hydraulic pipe bending machine
发布时间：2017-02-10 作者：admin 浏览量：1798
(1) wheel die (BENDING, DIE) (2) die clamping (CLAMP, DIE) Adjust: A, clamping die holder (FIG-7 (3) to relax, and then put the control panel in manual mode, press the pinch button (FIG-7 (3), to the end of clamping action). (at this time, there is a gap between the wheel die clamps and the clamping screw (FIG-7 (4)) to adjust the die holder. C, press the pinch button (FIG-4 (6) to clamp the die back, and then adjust the clamping screw (FIG-7 (4)) clockwise rotation about 1/2-1/4 circle. (3) guided mode (PRESSURE, DIE) B, the guide screw can be locked. B, adjust the guide frame adjusting screw (FIG-7 (6) to make the guide die and the wheel die completely closed. D, and then the guide die set screws (FIG-7 (6) can be locked. Installation: A, the mandrel in a clockwise direction into the feedthrough rod.
The front subframe on the right longitudinal beam pipe
Rear torsion beam; left and right trailing arm
Rear cross member assembly of rear subframe
Intake pipe assembly
Warm water outlet pipe assembly